Belt dryer Although it is more efficient and energy-efficient dryer, but in practice there will be a fault occurs, we have done is to identify the cause of the malfunction to be excluded, so that belt dryer to make the greatest energy efficiency for us service. So when customers buy belt dryer, pay attention to the configuration of the dryer, belt dryer on the selection of the filter with the dryer teeth and the teeth to adapt to the channel, the general selection of filter mesh diameter is dry Machine into the channel or aperture of 0.2 times. Belt dryer in the use of common faults which? How to solve? How to carry out maintenance? Kewei professionals to tell you a few points:
1, before the start of the air should be checked triple pieces of water will be discharged and to ensure adequate oil level.
2, to ensure that the dryer has a good grounding equipment, equipment, temperature measurement instrument should be measured.
3, parts inspection and maintenance, such as bearing lubricants, adjust the pulley, check the electrical wiring, the door of the rocker, pipe connections and so on and fixed.
4, raw material on fire failure, may be drying machine equipment design issues, or raw materials do not take the lead in the dryer, such as fire. In addition, there may be caused by human factors, such as in order to achieve the drying effect of the dryer is too small forcing heating caused by fire. At this point it is best to replace the transformation of the dryer equipment, check whether the correct installation of the dryer, whether the leak or increase the wind pressure and so on. Proper use of dryers, caution to increase the temperature of the dryer, so as not to cause fire.
5, a one-time drying of raw materials do not dry, mainly due to the dryer is too small or improper use of the dryer and other reasons. In addition, the wind network pressure, flow calculation error will lead to such failure. You can replace or re-modify the drying equipment, or require manufacturers to re-calculate the wind pressure, flow and other changes in the program. If it is due to improper operation, then the operator in strict accordance with the instructions for correct operation.
6, to ensure that the seat bolts are not loose, support elastic spring connection appropriate, computer board control, wind wheel, heat exchanger has a good flexibility.
7, to keep the equipment clean, wipe the equipment on a daily basis, clean up dust inside the dust box to ensure that ventilation. Periodically open the rear cover to clean the inside of the unit.